The 2632 Gag bit features a single-jointed mouthpiece made partly of Sweet Copper, designed for use with elevator cheek-pieces. When the rein is accepted, the cheek-pieces lift the bit, increasing pressure on the poll, bars and tongue — making it especially suited to strong, forward horses that need help to lift and carry themselves. The sweet-tasting copper link enhances acceptance and chewing.
Size Guide
Measure your horse’s mouth width by placing a bit sizer, string, or dowel between the corners of the lips (at the position where the bit will sit), mark the ends, then measure the distance.
The bit width should be such that the rings rest just outside (or very slightly beyond) the lip corners—if the bit is too narrow, it will pinch; too wide, it will shift side to side.
For loose ring bits, allow a little “play” so the rings can rotate freely without pinching the lips.
When mounted in the bridle, the bit should sit such that there is 1–2 small wrinkles at the corners of the mouth (but this is not a perfect rule for all jointed bits)
The bit should lie on the bars (the toothless gap between incisors and molars) and not press into teeth or interfere with the palate.
Size: 12.5 / 13.5 cm - Ring Diameter: 80 mm - Thickness: 21 mm
Composition
Mouthpiece: sweet copper - 90% copper, 7% zinc, 4% iron and aluminum hardened; Ring: stainless steel
Care Instructions
Washing
After each ride, rinse or wipe the bit to remove saliva, feed residues, or sweat. Use lukewarm water and, if needed, a mild, pH-neutral detergent or saddle soap. Avoid harsh chemicals or abrasive cleaners, as they can damage the metal surface and reduce the bit’s longevity.
Drying
Once cleaned, dry the bit thoroughly with a soft cloth. Allow it to air dry completely before storage. Do not expose the bit to direct sunlight, and never place it on or near heat sources such as heaters or radiators.
Storage
Store your bit in a dry, well-ventilated environment, protected from moisture and temperature fluctuations. For best results, keep bits individually or padded to prevent metal parts from rubbing or scratching each other. Avoid leaving the bit attached to the bridle for extended periods, especially in humid conditions.
Guidance
Any bit can cause pain if used roughly or improperly. The wrong size can also be painful for the horse.
This gag bit is designed to help elevate the horse’s front end and improve self-carriage by increasing bit, tongue, bar and poll influence when the rein is taken up. It should only be used by experienced riders who ride with soft, consistent aids and understand the biomechanical effect. Proper cheek piece fitting and bit alignment are critical to avoid discomfort.
